Keep them well when you finish using the green laser pointer

Change apertures () in width, to observe the center of the shielding effectiveness of shielded enclosures with our model: change apertures (slot) in width, to observe the center of the shielding effectiveness of shielded enclosures with width changes. Width changes. Changes create a parametric analysis 2.1.1 2.1 select the menu item HFSS> Optimetrics Analysis> Add Parametric 2.1.2 Editing Setup Sweep Analysis window (1) Click on the Setup Sweep Analysis window to the right top of the editor appears in the Add Add / Edit Sweep Dialog window ( 2) Add / Edit Sweep Dialog window of the Variable drop-down menu, select slot_width selected column in ascending Select: Linear step in the Start field, enter: 1 Stop bar enter:Some receivers are used exclusively, so keep them well when you finish using the    green laser pointer   . In the Step field, enter: 3 2 cm cm cm key (3) Click Add / Edit Sweep Dialog window, the Add button to the middle 31 (4) Click Add / Edit Sweep Dialog window to set the bottom of the OK button 2.1.3 Analysis of the initial parameters (1) Click on the Setup Sweep Analysis window at the top of the General key (2) Select (3) Select (4) Click Override key (5) Click the OK button to complete the initial parameter set. Setup1 2.1.4 parameter set to complete 32 Ansoft Xi'an University of Electronic Science and Technology Training Center 2.2 bar operating parameters analyzed in the project Optimetrics part of the expansion, right-click ParametricSetup1 click Analyze. 2.3     usa green laser pointer     is an equipment regarding laser as direction.Creating parametric curves (1) Select the menu item HFSS> Results> Create Report (2) Create Report Window: Report Type: Display Type: Click the OK button Fields Rectangualr Plot (3) the algorithm parameter selection box: Setup1: Sweep1 ( 4) Sweeps Set 1. Click Sweeps selection key 2. Select the Sweep design and project variable values 3. In the following parameter list area with the left mouse button click Normalize the first line item in the drop-down menu appears, click the Freq, frequency list and select the right top of the All Values. 4. Normalize column with the left mouse button click on the Points, and then click on the Edit Sweep key, press the graph settings, click the Update Values button, click the OK button, this is to take the center of the chassis. 335. The directing length of     green laser pointer      is very long.With the left mouse button double-click slot_width bar, and select the right frequency list at the top of All Values. (5) X-axis variable is set click on the X axis variable selection key to remove the Use Primary Sweep select the category area, select Variables, in the variables area, select Freq (6) Y-axis parameter settings click the Y-axis parameters selection key in the category area, select Output Variables, in the variable region selected shielding_effect. (7) to complete the curve parameters click on Add Trace key amendments to click Done button to complete the curve parameters of the amendment (8) observed parameters of the curve 34 Ansoft Xidian University Training Center 3 field distribution at the midpoint of the operational history of the tree before opening Planes " + "sign, select Global: xz, then right-click the project manager in the Field Overlays> Plot Fields> ComplexMag_E. If you change different laser heads of the     green laser pointer      you might get light spot in different shapes.Figure 7-18 Select a surface electric field distribution in Figure 7-19 to set up the dialog box shown in Figure 7-20, set the Solution: Setup1 Sweep1, set the frequency of 0.7GHz, click Done, the electric field distribution window will appear.